Redisplay Messages: Compact | Brief | All | Full Show Messages: All | Without Replies Author: | randyf | Posted: | Feb 6, 2020 22:03 | Subject: | Re: Inventory Change Request for Set 4484-1 | Viewed: | 26 times | Topic: | Inventories Requests | |
|
| In Inventories Requests, ZwarteMagica writes:
| Please make changes to the following inventory:
* Change 1 Part Black 2609b Magnet Holder Tile 2 x 2 - Tall Arms with Deep Notch {Regular to Extra}
* Change 2 Part Light Gray 4032 Plate, Round 2 x 2 with Axle Hole {Regular to Extra}
Comments from Submitter:
Since the 4871, 4854 and 6636 are extra items, I assume those parts also need to be listed as extra`s. Since they are also exclusive used in the cross over model.
|
According to BrickLink inventory guidelines, in the absence of an official parts
list for a set, the official part count on the set packaging can be used to determine
as closely as possible the contents of the Regular Items section of the set inventory:
https://www.bricklink.com/help.asp?helpID=1562
Since the official part count on the packaging for this set is 76 pieces, all
of the parts included in this set to be used to build the mini TIE bomber are
Regular Items.
Therefore, these requests will not be accepted, and I will adjust the inventory
manually to account for the required changes.
Cheers,
Randy
|
|
Author: | randyf | Posted: | Feb 6, 2020 20:58 | Subject: | Re: Inventory Change Request for Set 75236-1 | Viewed: | 27 times | Topic: | Inventories Requests | |
|
| In Inventories Requests, toontexas writes:
| Please make changes to the following inventory:
* Add 1 Part 87083 Dark Bluish Gray Technic, Axle 4 with Stop (Alternate) (match ID 1)
Comments from Submitter:
I parted out two sets. One set had a red axle 3703 plus a dbg axle 87083, the other set had only two dbg axles 87083 (no red axle).
|
The set requires one
and two
as shown on pages 35, 50, and 55 of the instructions as well as in the official
parts list.
Since the quantity of these parts is correct in the inventory, this request will
not be accepted.
Cheers,
Randy
|
|
Author: | randyf | Posted: | Feb 6, 2020 20:19 | Subject: | Re: Inventory Change Request for Part spa0010 | Viewed: | 25 times | Topic: | Inventories Requests | |
|
| In Inventories Requests, Gemini343 writes:
| Please make changes to the following inventory:
* Change {4 to 5} Part Dark Green 3023 Plate 1 x 2
Comments from Submitter:
According to the picture and instructions there should be two per leg and one on the torso.
|
Thank you for finding this error!
Instead of the fifth
there is a misplaced
in the inventory.
I have accepted this request and made the additional change manually.
Cheers,
Randy
|
|
Author: | randyf | Posted: | Feb 6, 2020 18:16 | Subject: | Re: The 6x6 tiles in 10227 B-Wing | Viewed: | 55 times | Topic: | Catalog | |
|
| In Catalog, rick_holl writes:
| Anyone knows if those tiles are flat or they have a shiny finish?
Thank you
|
6 x 6 tiles have a matte finish.
Cheers,
Randy
|
Author: | rick_holl | Posted: | Feb 6, 2020 16:52 | Subject: | The 6x6 tiles in 10227 B-Wing | Viewed: | 104 times | Topic: | Catalog | Status: | Open | |
|
| Anyone knows if those tiles are flat or they have a shiny finish?
Thank you
|
Author: | apple_brick | Posted: | Feb 6, 2020 06:19 | Subject: | Re: catalogue problem - zero lots showing up | Viewed: | 54 times | Topic: | Catalog | |
|
| | | It may have to do with the software they use to upload and sync their inventory.
This shouldn't be possible, however. Zero QTY lots should only be retained
in a stockroom.
|
|
Hi Russelm
All our zero qty lots are in stockroom. So seems like a BL bug.
|
|
Author: | apple_brick | Posted: | Feb 6, 2020 06:10 | Subject: | Re: catalogue problem - zero lots showing up | Viewed: | 42 times | Topic: | Catalog | |
|
| Hi Russell,
Someone just pointed me to this topic, which i never saw earlier.
Can this be the reason that lots are 'disappearing' from our inventory?
That would be a bad thing to do i think. Can you confirm this?
Today i noticed a lot of older regular items have been removed / or renewed with
a different Lot Id. That's causing issues on our side.
Maybee you can contact us, so we can discuss this?
Regards,
Rick
|
|
Author: | FreeStorm | Posted: | Feb 6, 2020 06:07 | Subject: | Inventory Change Request for Set 7760-1 | Viewed: | 24 times | Topic: | Inventories Requests (Entry) | Status: | Open | |
|
| Please make changes to the following inventory:
* | | 7760-1 (Inv) Electric Diesel Locomotive (Diesel Shunter Locomotive) 144 Parts, 2 Minifigures, 1980 Sets: Train: 12V |
* Change {1 to 2} Part Blue 3004pb033 Brick 1 x 2 with White '7760' Pattern (Sticker) - Set 7760 (Counterpart)
Comments from Submitter:
Add another part for right side of the locomotive.
|
|
Author: | StormChaser | Posted: | Feb 6, 2020 03:44 | Subject: | Re: Correction sheet for set 8847 | Viewed: | 33 times | Topic: | Catalog | |
|
| In Catalog, anathema writes:
| The same applies to set 8843, too - I have the supplemental sheet (which I'll
add in the next few days when I get it scanned) and the updated version of the
instructions.
|
BrickLink does not have any record in the inventory of this set of a redesign.
However, I have added a note to the instructions anyway:
You might see about updating the set inventory when you get a minute.
|
|
Author: | anathema | Posted: | Feb 6, 2020 03:39 | Subject: | Re: Correction sheet for set 8847 | Viewed: | 30 times | Topic: | Catalog | |
|
| In Catalog, StormChaser writes:
| In Catalog, anathema writes:
| Could you also add a note to say that there are two versions of the instruction
booklet too, please? The booklet was updated to incorporate the changes from
the supplemental sheet.
|
Well . . . okay. You talked me into it. You have your note.
|
Thanks!
The same applies to set 8843, too - I have the supplemental sheet (which I'll
add in the next few days when I get it scanned) and the updated version of the
instructions.
|
|
Author: | StormChaser | Posted: | Feb 6, 2020 03:11 | Subject: | Re: Correction sheet for set 8847 | Viewed: | 34 times | Topic: | Catalog | |
|
| In Catalog, anathema writes:
| Could you also add a note to say that there are two versions of the instruction
booklet too, please? The booklet was updated to incorporate the changes from
the supplemental sheet.
|
Well . . . okay. You talked me into it. You have your note.
|
|
Author: | anathema | Posted: | Feb 6, 2020 03:05 | Subject: | Re: Correction sheet for set 8847 | Viewed: | 37 times | Topic: | Catalog | |
|
| In Catalog, StormChaser writes:
| In Catalog, Adjour writes:
| The old dragster set has a white correction sheet for step 16. It has a part
number on the page that doesn't show up in searches (120356).
Am I missing the entry somewhere? If not, should an entry exist? Or a note with
the instructions entry? (I could have sworn I had seen a note about this previously...)
Thanks!!
|
The inventory does show that the set was redesigned during production. Please
upload a scan of the correction sheet to the instruction entry for the set and
we'll add it as an alternate image.
|
Could you also add a note to say that there are two versions of the instruction
booklet too, please? The booklet was updated to incorporate the changes from
the supplemental sheet.
|
|
Author: | Adjour | Posted: | Feb 6, 2020 00:51 | Subject: | Re: Correction sheet for set 8847 | Viewed: | 35 times | Topic: | Catalog | |
|
| In Catalog, StormChaser writes:
| In Catalog, Adjour writes:
| The old dragster set has a white correction sheet for step 16. It has a part
number on the page that doesn't show up in searches (120356).
Am I missing the entry somewhere? If not, should an entry exist? Or a note with
the instructions entry? (I could have sworn I had seen a note about this previously...)
Thanks!!
|
The inventory does show that the set was redesigned during production. Please
upload a scan of the correction sheet to the instruction entry for the set and
we'll add it as an alternate image.
|
Sweet! Its late here, so I'll see what I can do tomorrow.
Thanks!!
|
|
Author: | StormChaser | Posted: | Feb 6, 2020 00:40 | Subject: | Re: Correction sheet for set 8847 | Viewed: | 34 times | Topic: | Catalog | |
|
| In Catalog, Adjour writes:
| The old dragster set has a white correction sheet for step 16. It has a part
number on the page that doesn't show up in searches (120356).
Am I missing the entry somewhere? If not, should an entry exist? Or a note with
the instructions entry? (I could have sworn I had seen a note about this previously...)
Thanks!!
|
The inventory does show that the set was redesigned during production. Please
upload a scan of the correction sheet to the instruction entry for the set and
we'll add it as an alternate image.
|
|
Author: | Adjour | Posted: | Feb 6, 2020 00:36 | Subject: | Correction sheet for set 8847 | Viewed: | 80 times | Topic: | Catalog | Status: | Open | |
|
| The old dragster set has a white correction sheet for step 16. It has a part
number on the page that doesn't show up in searches (120356).
Am I missing the entry somewhere? If not, should an entry exist? Or a note with
the instructions entry? (I could have sworn I had seen a note about this previously...)
Thanks!!
|
|