| Discussion Forum: Thread 217675 |
|
 |
| | | Author: | bshav  | | Posted: | Mar 7, 2017 16:07 | | Subject: | Inventory Change Request for Set 7674-1 | | Viewed: | 22 times | | Topic: | Inventories Requests (Entry) | | Status: | Open | |
|
| Please make changes to the following inventory:
* Change {1 to 2} Part Yellow 40490 Technic, Liftarm 1 x 9 Thick
Comments from Submitter:
You require 2x of the Yellow Technic Lift Arm,one for each wing.
|
|
| | | | | |
| | | | | Author: | randyf | | Posted: | Mar 7, 2017 16:30 | | Subject: | Re: Inventory Change Request for Set 7674-1 | | Viewed: | 22 times | | Topic: | Inventories Requests | |
|
| In Inventories Requests, booooze writes:
| | Please make changes to the following inventory:
* Change {1 to 2} Part Yellow 40490 Technic, Liftarm 1 x 9 Thick
Comments from Submitter:
You require 2x of the Yellow Technic Lift Arm,one for each wing.
|
This is incorrect. There is only one of these lift arms in the set. The lift
arm is only used as a support while the engines are being built on each side
of the model. When the first engine is built, it is attached to the engine sides
for support with two black Technic pins. One step later, the pins and lift arm
scaffold is shown in the instructions being removed from the engine after it
is securely attached to the main model. This process is repeated for the second
engine using the *same* pins and lift arm scaffold. After the model is complete,
the pins and lift arm are not attached to the model in any way.
Cheers,
Randy
|
|
|
| | | | | |
| | | | | Author: | viejos | | Posted: | Mar 7, 2017 16:33 | | Subject: | Re: Inventory Change Request for Set 7674-1 | | Viewed: | 22 times | | Topic: | Inventories Requests | |
|
| In Inventories Requests, booooze writes:
| | Please make changes to the following inventory:
* Change {1 to 2} Part Yellow 40490 Technic, Liftarm 1 x 9 Thick
Comments from Submitter:
You require 2x of the Yellow Technic Lift Arm,one for each wing.
|
This liftarm is only used to keep parts lined up during assembly. When one wing
is built, the liftarm is removed and used for the other wing. Then the liftarm
is removed again. See images below.
|
|
|
|
|
|
|
Canada, British Columbia
USA, Ohio
)
)