| Redisplay Messages: Compact | Brief | All | Full Show Messages: All | Without Replies Re: Change Part Dimensions to Metric - brickerking (1880) | [...] You seem very opposed to the idea of using international standards of measurement for user input or just playing devil's advocate. I'm not sure why, but I'm [...] (41 months ago, Jan 15, 2021, to Suggestions) |
Re: Change Part Dimensions to Metric - brickerking (1880) | [...] Yes, I agree, placing a piece across studs is pretty easy, although not very accurate. It is better to start off accurate and then round up or down to stud length on [...] (41 months ago, Jan 15, 2021, to Suggestions) |
Re: Change Part Dimensions to Metric - brickerking (1880) | [...] It's a moot point now, since this is actually being implemented, but my point is that when adding part sizes, doing that by stud and brick height is not easy in most [...] (41 months ago, Jan 15, 2021, to Suggestions) |
Re: Change Part Dimensions to Metric - brickerking (1880) | [...] This is exactly what I'm asking for. I'm aware that I can change them for my own store, but I'm thinking of the greater good. I want to change them for everyone [...] (41 months ago, Jan 15, 2021, to Suggestions) |
Re: Change Part Dimensions to Metric - brickerking (1880) | [...] Let's hope so! Although I think you are reading a lot between-the-lines in those two posts as my specific request is not mentioned. Hopefully if it's not on the [...] (41 months ago, Jan 15, 2021, to Suggestions) |
Next Page: 5 More | 10 More | 25 More | 50 More | 100 More
|
|