Redisplay Messages: Compact | Brief | All | Full Show Messages: All | Without Replies| Author: | normann1974  | | Posted: | May 22, 2018 09:41 | | Subject: | Inventory Change Request for Set 8436-1 | | Viewed: | 29 times | | Topic: | Inventories Requests (Entry) | | Status: | Open | |
|
| Please make changes to the following inventory:
* Add 4 Part 4032b Light Bluish Gray Plate, Round 2 x 2 with Axle Hole - X Opening (Alternate) (match ID 2)
* Change 4 Part Light Bluish Gray 4032 Plate, Round 2 x 2 with Axle Hole {match ID 0 to 2}
Comments from Submitter:
Source: MISB-based set that was only assembled once and then stored in a sealed bag (never mixed with other bricks).
|
 |
|
| Author: | UtinniBricks | | Posted: | May 21, 2018 22:58 | | Subject: | Partial/selective inventory store closing? | | Viewed: | 145 times | | Topic: | Suggestions | | Status: | Discarded | |
|
| Sometimes events in life do not allow time to process large parts orders, but
filling quick minifig or set orders is quick enough to process. It'd be nice
to be able to partially close specific sections of your store and not all or
nothing...
I suppose running 2 stores is a possibility, but I would rather see this option
installed.
|
|
| Author: | hobbyist69 | | Posted: | May 21, 2018 05:29 | | Subject: | Inventory Change Request for Set 2644-1 | | Viewed: | 38 times | | Topic: | Inventories Requests (Entry) | | Status: | Open | |
|
| Please make changes to the following inventory:
* Add 1 Part x1582 Yellow Duplo Hook Long with Cross Bar
Comments from Submitter:
As shown in the picture used on your site on the back of the truck. The picture shows the item in red although I can only find evidence of yellow ones being provided or available.
|
|
| Author: | SezaR | | Posted: | May 21, 2018 01:48 | | Subject: | Re: Inventory Change Request for Set 7745-1 | | Viewed: | 18 times | | Topic: | Inventories Requests | |
|
| Correction:
| | 3) Since last time, the submitter of this inventory change found a travel machine and used it to discuss this change of part with few managers of TLG in 1986. They provide him a special type of evidence, leaving no doubt to admin of bricklink.
|
"time machine"
|
|
| Author: | SezaR | | Posted: | May 21, 2018 01:46 | | Subject: | Inventory Change Request for Set 7745-1 | | Viewed: | 51 times | | Topic: | Inventories Requests (Entry) | | Status: | Open | |
|
| Please make changes to the following inventory:
* Add 1 Part 2776c28 Light Gray Electric, Wire 12V / 4.5V with 2 male Squared Narrow Short connectors, 28 Studs Long (Alternate) (match ID 4)
* Change 1 Part Light Gray 765c28 Electric, Wire 12V / 4.5V with four 1-prong connectors, 28 Studs Long {match ID 0 to 4}
Comments from Submitter:
Admin has the choice to obtain any of the following types of evidence:
1) Photos of several used sets;
2) Photos of a sealed set;
3) Since last time, the submitter of this inventory change found a travel machine and used it to discuss this change of part with few managers of TLG in 1986. They provide him a special type of evidence, leaving no doubt to admin of bricklink.
|
|
| Author: | phyllisw8 | | Posted: | May 20, 2018 15:57 | | Subject: | Inventory Change Request for Set 75873-1 | | Viewed: | 22 times | | Topic: | Inventories Requests (Entry) | | Status: | Open | |
|
| Please make changes to the following inventory:
* Add 1 Part 24309pb008L Black Slope, Curved 3 x 2 No Studs with 'quattro GmbH' and Front Bumper Left Pattern (Sticker) - Set 75873 (Counterpart)
* Add 1 Part 24309pb008R Black Slope, Curved 3 x 2 No Studs with 'quattro GmbH' and Front Bumper Right Pattern (Sticker) - Set 75873 (Counterpart)
* Add 1 Part 93273pb086 Dark Bluish Gray Slope, Curved 4 x 1 Double No Studs with 2 Exhaust Pipes Pattern (Sticker) - Set 75873 (Counterpart)
* Add 1 Part 93606pb075 White Slope, Curved 4 x 2 No Studs with 'Audi' and Rear Window Louvers Pattern (Sticker) - Set 75873 (Counterpart)
* Add 1 Part 93606pb076 White Slope, Curved 4 x 2 No Studs with 'Sport' and Rear Window Louvers Pattern (Sticker) - Set 75873 (Counterpart)
|
|
|
| Author: | rtjepsen | | Posted: | May 20, 2018 13:19 | | Subject: | Inventory Change Request for Gear 852751 | | Viewed: | 24 times | | Topic: | Inventories Requests (Entry) | | Status: | Open | |
|
| Please make changes to the following inventory: [G=852751]
* Add 2 Part 30377 White Arm Mechanical, Battle Droid
Comments from Submitter:
One each make up the Knights piece on the imperial soldier's side. It holds the horse battle helmet on, just like it does in Gear 852001
|
| Author: | QBricks | | Posted: | May 20, 2018 06:01 | | Subject: | Inventory Change Request for Book 9780756682767 | | Viewed: | 27 times | | Topic: | Inventories Requests (Entry) | | Status: | Open | |
|
| Please make changes to the following inventory: [B=9780756682767]
* Delete 1 Part 4497u Dark Brown Minifig, Weapon Pike / Spear - Undetermined End
* Add 1 Part 93789 Dark Brown Minifig, Weapon Pike / Spear - Flat End
|
|
| Author: | Hygrotus | | Posted: | May 20, 2018 05:00 | | Subject: | Re: Inventory Change Request for Book 9780756682767 | | Viewed: | 23 times | | Topic: | Inventories Requests | |
|
| In Inventories Requests, QBricks writes:
| | Please make changes to the following inventory: [B=9780756682767]
* Add 10 Part 30241b Black Brick, Modified 1 x 1 with Clip Vertical (open O clip) - Hollow Stud (Alternate) (match ID 1)
* Change 10 Part Black 30241 Brick, Modified 1 x 1 with Clip Vertical {Regular to Alternate} {match ID 0 to 1}
Comments from Submitter:
Found in multiple sealed copies
|
Hi
In this inventory there is also this part undetermined
so can you check it also what variant do you have and correct it?
Marek
|
|
| Author: | QBricks | | Posted: | May 20, 2018 04:24 | | Subject: | Inventory Change Request for Book 9780756682767 | | Viewed: | 26 times | | Topic: | Inventories Requests (Entry) | | Status: | Open | |
|
| Please make changes to the following inventory: [B=9780756682767]
* Add 10 Part 30241b Black Brick, Modified 1 x 1 with Clip Vertical (open O clip) - Hollow Stud (Alternate) (match ID 1)
* Change 10 Part Black 30241 Brick, Modified 1 x 1 with Clip Vertical {Regular to Alternate} {match ID 0 to 1}
Comments from Submitter:
Found in multiple sealed copies
|
|
| Author: | Brickwilbo | | Posted: | May 19, 2018 14:59 | | Subject: | Re: Apply cart to wanted list | | Viewed: | 43 times | | Topic: | Suggestions | |
|
| In Suggestions, IQ1970 writes:
| | Is there a way to apply a cart to a wanted list?
|
You can add items in the cart to a Wantlist.
| |
I know there is the option to "Apply Order" to a wanted list. However I want
to play around a bit with my wanted lists to figure out the best prices before
I start the actual ordering.
|
You can use the Buy tab search option a few times over and over, create a cart
each time, then compare the carts on multiple browser tabs.
Unfortunately the Buy feature doesn't allow to do multiple searches because
after it finds a store and you create a cart you need to go back again and search
again.
Or use the classic view By Shop option to find the stores with the most parts
and to create multiple carts. https://www.bricklink.com/wantedShop.asp?showOld=Y
|
|
| Author: | Enantiomeer | | Posted: | May 19, 2018 14:43 | | Subject: | Apply cart to wanted list | | Viewed: | 71 times | | Topic: | Suggestions | | Status: | Already Exists | |
|
| Is there a way to apply a cart to a wanted list?
I know there is the option to "Apply Order" to a wanted list. However I want
to play around a bit with my wanted lists to figure out the best prices before
I start the actual ordering.
|
| Author: | StormChaser | | Posted: | May 19, 2018 03:42 | | Subject: | Re: Inventory Change Request for Set 1000-1 | | Viewed: | 24 times | | Topic: | Inventories Requests | |
|
| In Inventories Requests, StormChaser writes:
| | In Inventories Requests, StormChaser writes:
| | Only 10 blank tiles are visible in current set photo.
|
After some additional effort, I found a poor-quality image of the parts list.
It confirms that the number should be 10.
|
Larger, higher-quality image makes this a certainty.
|
|
|
| Author: | StormChaser | | Posted: | May 19, 2018 03:12 | | Subject: | Re: Inventory Change Request for Set 42021-1 | | Viewed: | 23 times | | Topic: | Inventories Requests | |
|
| In Inventories Requests, samsam2 writes:
| | I understand how a sticker can be applied to the wrong part and then mistakenly
added to the catalog, but how can so many sellers have a non-existant part for
sale?
|
Because sellers trust BrickLink to have correct catalog entries and inventories.
Unfortunately, not all entries and inventories are correct.
An example of sellers listing non-existent items for sale can be seen here:
https://www.bricklink.com/messageThread.asp?ID=228184&nID=1063060
In this instance numerous sellers listed non-existent set instructions for sale
because the catalog listing showed that the set came with instructions.
Thank you for taking the time to correct the inventory for set 42021-1.
|
|
| Author: | Hygrotus | | Posted: | May 19, 2018 01:46 | | Subject: | Inventory Change Request for Set 70643-1 | | Viewed: | 22 times | | Topic: | Inventories Requests (Entry) | | Status: | Open | |
|
| Please make changes to the following inventory:
* Change 1 Part Yellow {24581pb01 Minifig, Baby / Toddler Head, Black Eyes, White Pupils and Smile Pattern to bb851pb01 Minifig, Baby / Toddler Head with Neck, Black Eyes, White Pupils and Smile Pattern}
Comments from Submitter:
This set has new mould variant of this part. It is clearly visible in this video review, time 6:33: https://www.youtube.com/watch?v=f7Y5PoUq4R8. Also confirmed by member axaday who verified this set inventory.
|
|
| Author: | axaday | | Posted: | May 18, 2018 18:16 | | Subject: | Inventory Change Request for Set 75212-1 | | Viewed: | 26 times | | Topic: | Inventories Requests (Entry) | | Status: | Open | |
|
| Please make changes to the following inventory:
* Add 1 Part 4697b Light Bluish Gray Pneumatic T Piece New Style (T Bar) (Extra)
|
|
| Author: | Brickwilbo | | Posted: | May 18, 2018 13:21 | | Subject: | Re: Blocking a store | | Viewed: | 89 times | | Topic: | Suggestions | |
|
| In Suggestions, wolbar writes:
| | Hi, I have been stopped / blocked by a rather thin skinned seller.
Is there a way I can block the store? I don't want to see the store any longer
or be able to add items from its inventory. I have gone to the store twice now
to add items only to find out I am blocked.
That is annoying me and there should be a way for a buyer to block a seller in
turn.
|
Here's the link https://www.bricklink.com/searchSettings.asp?viewFrom=P
|
|
| Author: | Dino | | Posted: | May 18, 2018 12:58 | | Subject: | Re: Blocking a store | | Viewed: | 51 times | | Topic: | Suggestions | |
|
| In Suggestions, wolbar writes:
| | Hi, I have been stopped / blocked by a rather thin skinned seller.
Is there a way I can block the store? I don't want to see the store any longer
or be able to add items from its inventory. I have gone to the store twice now
to add items only to find out I am blocked.
That is annoying me and there should be a way for a buyer to block a seller in
turn.
|
Go "My settings" - "My Search Settings". There you can exclude this stores.
|
Next Page: 5 More | 10 More | 25 More | 50 More | 100 More
|
Denmark
USA, California
United Kingdom, England
Canada, British Columbia
Poland, w. Wielkopolskie
Australia, Queensland
Netherlands, Gelderland
Luxembourg