| Discussion Forum: Thread 306632 |
|
 |
| | | Author: | bahpstore  | | Posted: | Jul 16, 2021 18:56 | | Subject: | Please help with handling 2429c01 in studio | | Viewed: | 42 times | | Topic: | Related Software | |
|
| I'm just learning to use studio. Could someone show me how to bend 2429c01?
I'm trying to connect 32 of them into a two-layer circle. Thank you!
|
|
|
| | | | | |
| | | | | Author: | Hexy | | Posted: | Jul 16, 2021 19:27 | | Subject: | Re: Please help with handling 2429c01 in studio | | Viewed: | 28 times | | Topic: | Related Software | |
|
| Hi,
Sadly, it is very fiddly. The first thing you have to do is individually create
the hinge plate out of the two sides (You can't use the prebuilt one). Then
you have to go up to the top bar and select the hinge tool, then individually
select each piece and bent it to the right angle on the circle
There is probably a more efficient way to do it but I haven't used stud.io
in a while. (If this doesn't help try going here and creating another forum
post)
[https://forum.bricklink.com/index.php?sid=ebd1fa8d6e6ed14b767cee504cacba20]
Hope this helps!
Kind Regards,
Theo - The_RealRedHex
In Related Software, bricklinklp writes:
| | I'm just learning to use studio. Could someone show me how to bend 2429c01?
I'm trying to connect 32 of them into a two-layer circle. Thank you!
|
|
|
|
| | | | | | | | | |
| | | | | | | Author: | bahpstore | | Posted: | Jul 16, 2021 19:46 | | Subject: | Re: Please help with handling 2429c01 in studio | | Viewed: | 43 times | | Topic: | Related Software | |
|
| In Related Software, The_RealRedHex writes:
| | Hi,
Sadly, it is very fiddly. The first thing you have to do is individually create
the hinge plate out of the two sides (You can't use the prebuilt one). Then
you have to go up to the top bar and select the hinge tool, then individually
select each piece and bent it to the right angle on the circle
There is probably a more efficient way to do it but I haven't used stud.io
in a while. (If this doesn't help try going here and creating another forum
post)
[https://forum.bricklink.com/index.php?sid=ebd1fa8d6e6ed14b767cee504cacba20]
Hope this helps!
Kind Regards,
Theo - The_RealRedHex
In Related Software, bricklinklp writes:
| | I'm just learning to use studio. Could someone show me how to bend 2429c01?
I'm trying to connect 16 of them into a two-layer circle. Thank you!
|
|
Thank you very much, I'll try it. Studio isn't a very user friendly software
|
|
|
|
|
|
|
USA, Virginia
Australia, Victoria