Discussion Forum: Thread 230394 |
|
|
| | Author: | mattmailing | Posted: | Jan 7, 2018 16:54 | Subject: | Inventory Change Request for Set 6923-1 | Viewed: | 28 times | Topic: | Inventories Requests (Entry) | Status: | Open | |
|
| Please make changes to the following inventory:
* Add 2 Part 3794 Red Plate, Modified 1 x 2 with 1 Stud (Jumper)
Comments from Submitter:
AS SEEN ON P15 OF THE MANUAL
|
|
| | | | | |
| | | | Author: | StormChaser | Posted: | Jan 7, 2018 16:59 | Subject: | Re: Inventory Change Request for Set 6923-1 | Viewed: | 16 times | Topic: | Inventories Requests | |
|
| In Inventories Requests, mattmailing writes:
| Comments from Submitter:
AS SEEN ON P15 OF THE MANUAL
|
Please post a photo or scan of the relevant portion of the set instructions.
|
|
| | | | | |
| | | | Author: | StormChaser | Posted: | Jan 7, 2018 17:16 | Subject: | Re: Inventory Change Request for Set 6923-1 | Viewed: | 22 times | Topic: | Inventories Requests | |
|
| In Inventories Requests, mattmailing writes:
| Please make changes to the following inventory:
* Add 2 Part 3794 Red Plate, Modified 1 x 2 with 1 Stud (Jumper)
Comments from Submitter:
AS SEEN ON P15 OF THE MANUAL
|
Ah, I see now the location of the confusion:
The parts are included in this figure and thus the set inventory, so this request
has not been approved. This is a frequent issue which will be resolved when
the system is able to treat minifigures as counterparts (which I am hoping will
happen within the next few years or so).
In the meantime, click the Break Minifigs link at the top of the page
to avoid further difficulties.
|
|
|
|
|
|
|