Discussion Forum: Thread 105309

 Author: leggodtshop View Messages Posted By leggodtshop
 Posted: Dec 18, 2010 13:12
 Subject: Reference to new item # if changed
 Viewed: 68 times
 Topic: Suggestions
 Status:Open
 Vote:[Yes|No]
Cancel Message
Cancel
Reply to Message
Reply
BrickLink
ID Card

leggodtshop (3861)

Location:  Netherlands, Overijssel
Member Since Contact Type Status
Aug 11, 2006 Contact Member Seller
Buying Privileges - OKSelling Privileges - OK
Store: Leggodt.nl
Once in a while item # are changed by Catalog Admins. This by itself is not a
problem.

However I have a local administration using hyperlinks to items in the Catalog.

E.g. http://www.bricklink.com/catalogItem.asp?M=santafig3

Yes, this items has been re-numbered.... (image 1)

The change in the number is known to BL in the change log (image 2)

Now, pls could BL show the new number (as a link) on the error page? (image 1)

Then I do not have to start searching the Catalog again which fig it was... but
instead directly click the link provided to go the correct entry.

Thx,
Arnoud
 


 Author: steekstra View Messages Posted By steekstra
 Posted: Dec 18, 2010 13:21
 Subject: (Cancelled)
 Viewed: 24 times
 Topic: Suggestions
Cancel Message
Cancel
Reply to Message
Reply
BrickLink
ID Card

steekstra (4360)

Location:  Netherlands, Friesland
Member Since Contact Type Status
May 21, 2009 Contact Member Seller
Buying Privileges - OKSelling Privileges - OK
Store Closed Store: HOLLANDIA STENEN
(Cancelled)
 Author: leggodtshop View Messages Posted By leggodtshop
 Posted: Dec 18, 2010 13:41
 Subject: Re: Reference to new item # if changed
 Viewed: 32 times
 Topic: Suggestions
Cancel Message
Cancel
Reply to Message
Reply
BrickLink
ID Card

leggodtshop (3861)

Location:  Netherlands, Overijssel
Member Since Contact Type Status
Aug 11, 2006 Contact Member Seller
Buying Privileges - OKSelling Privileges - OK
Store: Leggodt.nl
In Suggestions, steekstra writes:
  In Suggestions, patpendlego writes:
  Once in a while item # are changed by Catalog Admins. This by itself is not a
problem.

However I have a local administration using hyperlinks to items in the Catalog.

E.g. http://www.bricklink.com/catalogItem.asp?M=santafig3

Yes, this items has been re-numbered.... (image 1)

The change in the number is known to BL in the change log (image 2)

Now, pls could BL show the new number (as a link) on the error page? (image 1)

Then I do not have to start searching the Catalog again which fig it was... but
instead directly click the link provided to go the correct entry.

Thx,
Arnoud

Hi Arnoud

What would happen when it's in your inventory, admin send you a e-mail about
it ??

Ore is there a blank in your inventory ??

Jonathan just from Holland too

On my BL inventory the item is simply re-numbered, no problem.

It is just my 'backoffice' local administration (in Excel) that has the old number,
and it needs to be updated. An e-mail won't do it always, because not all items
are in my BL inventory.