| Redisplay Messages: Compact | Brief | All | Full Show Messages: All | Without Replies Author: | axaday | Posted: | Jul 6, 2019 21:33 | Subject: | Question For Someone with Underminer Minifies | Viewed: | 97 times | Topic: | Catalog | Status: | Open | |
|
wears this cape
I am usually a fan of dynamically posed catalog pics, but this time I just can't
tell if this piece is the same cut as a new piece that I need to get into the
catalog. Can someone tell me if the attached pic is the same shape?
|
|
|
Author: | Admin_Russell | Posted: | Jul 6, 2019 12:53 | Subject: | Re: Stickered Assembly numbering BA77pb01 | Viewed: | 47 times | Topic: | Catalog | |
| In Catalog Requests, samsam2 writes:
| Not sure if sequence number for multiple stickered assembly parts from same set
should increment the 'pb01' to 'pb02' rather than from BA76pb01
to BA77pb01. The part I'm questioning is [p=BA77pb01] and if it should actually
become [p=BA76pb02]
|
Only if the brick configuration is exactly the same. In fact, the numbering has
nothing to do with which set it came from. If the brick configuration is the
same as an entry already in the catalog, use that entry's number and increment
the pbxx value by one.
|
|
Author: | samsam2 | Posted: | Jul 6, 2019 12:28 | Subject: | Stickered Assembly numbering BA77pb01 | Viewed: | 48 times | Topic: | Catalog | Status: | Open | |
| Not sure if sequence number for multiple stickered assembly parts from same set
should increment the 'pb01' to 'pb02' rather than from BA76pb01
to BA77pb01. The part I'm questioning is [p=BA77pb01] and if it should actually
become [p=BA76pb02]
|
Author: | bb1429717 | Posted: | Jul 4, 2019 19:19 | Subject: | 700e H Baseplate? | Viewed: | 104 times | Topic: | Catalog | Status: | Open | |
| In the catalog I see there are a few varients of the 700e early baseplate, but
I recently ran across a couple with numbers that werent in the catolog. They
are most similar to the 700eD plates, but to have different featured like the
shape of the cross supports where they cross, and are marked '700 e H'
on the bottom.
Should The 700e H varient be added and/or does anyone know anything about this
baseplate? (sorry I'm very new here or I would attempt to add it myself)
|
|
Author: | mr.misior | Posted: | Jul 4, 2019 18:37 | Subject: | Re: holographic tile ID please | Viewed: | 25 times | Topic: | Catalog | |
| In Catalog, cycbuild writes:
| In Catalog, mr.misior writes:
| could someone please tell me which set this belongs to.
the face is holographic and only visible at certain angle.
|
|
thank you!
|
Next Page: 5 More | 10 More | 25 More | 50 More | 100 More
|
|