Discussion Forum: Thread 310395 |
|
|
| | Author: | gmanjozi | Posted: | Oct 5, 2021 10:21 | Subject: | Bug in Studio v2.2.9(1) ? | Viewed: | 48 times | Topic: | Related Software | |
|
| When importing an LXF file, program no longer shows you all the parts in the
right list in the steps section on certain lxf files.
Clicking on a part also does not highlight the part on the model, and also because
there is no list on the right, you can't see the relevant part and in what
step it is.
You also can't insert and snap any new parts to any of the parts in the model
unless you delete a part and undo, then the original lxf part can be snapped
to.
Doesn't even work if I save the model immediately after opening the lxf to
a .oi file. Upon opening the .io file, the same issues still present.
Also, from time to time, the project name tab that normally sits at the top doesn't
display, other times when importing the lxf the tab simply says "untitled model"
instead of the file name.
In the two files attached you can see one lxf works fine, another doesn't.
Any idea why this would be happening?
|
|
|
|
| | | | | |
| | | | Author: | gmanjozi | Posted: | Oct 5, 2021 10:22 | Subject: | Re: Bug in Studio v2.2.9(1) ? | Viewed: | 19 times | Topic: | Related Software | |
|
| This is image of working lXF |
|
|
| | | | | |
| | | | Author: | MrPetovan | Posted: | Oct 5, 2021 10:23 | Subject: | Re: Bug in Studio v2.2.9(1) ? | Viewed: | 28 times | Topic: | Related Software | |
|
| Hi, the Studio-specific forum is independent from this one, you may have better
luck with your issue over there:
https://forum.bricklink.com/
In Related Software, gmanjozi writes:
| When importing an LXF file, program no longer shows you all the parts in the
right list in the steps section on certain lxf files.
Clicking on a part also does not highlight the part on the model, and also because
there is no list on the right, you can't see the relevant part and in what
step it is.
You also can't insert and snap any new parts to any of the parts in the model
unless you delete a part and undo, then the original lxf part can be snapped
to.
Doesn't even work if I save the model immediately after opening the lxf to
a .oi file. Upon opening the .io file, the same issues still present.
Also, from time to time, the project name tab that normally sits at the top doesn't
display, other times when importing the lxf the tab simply says "untitled model"
instead of the file name.
In the two files attached you can see one lxf works fine, another doesn't.
Any idea why this would be happening?
|
|
|
|
| | | | | | | | | |
| | | | | | Author: | gmanjozi | Posted: | Oct 5, 2021 10:28 | Subject: | Re: Bug in Studio v2.2.9(1) ? | Viewed: | 20 times | Topic: | Related Software | |
|
| Thanks will post it there. |
|
|
|
|
|