| Discussion Forum: Thread 272786 |
|
 |
| | | Author: | rimwall  | | Posted: | Aug 4, 2020 19:32 | | Subject: | Inventory Change Request for Set 6841-1 | | Viewed: | 32 times | | Topic: | Inventories Requests (Entry) | | Status: | Open | |
|
| Please make changes to the following inventory:
* Change 1 Part Light Gray {3039p34 Slope 45 2 x 2 with Computer Panel Pattern to 3039 Slope 45 2 x 2}
Comments from Submitter:
Hi,
I think this 2 x 2 slope part should be plain 3039 (no computer panel printed). I can't see any evidence in the instructions or on images of the box that it has a printed computer panel. If there are printed parts that can't be seen, the instructions normally have an extra picture in a box showing the printed face. That is not the case here.
Keep up the good work at BrickLink - it's an amazing website.
Thanks!
|
|
| | | | | |
| | | | | Author: | elias3 | | Posted: | Aug 4, 2020 22:05 | | Subject: | Re: Inventory Change Request for Set 6841-1 | | Viewed: | 19 times | | Topic: | Inventories Requests | |
|
| In Inventories Requests, rimwall writes:
| | Please make changes to the following inventory:
* Change 1 Part Light Gray {3039p34 Slope 45 2 x 2 with Computer Panel Pattern to 3039 Slope 45 2 x 2}
Comments from Submitter:
Hi,
I think this 2 x 2 slope part should be plain 3039 (no computer panel printed). I can't see any evidence in the instructions or on images of the box that it has a printed computer panel. If there are printed parts that can't be seen, the instructions normally have an extra picture in a box showing the printed face. That is not the case here.
Keep up the good work at BrickLink - it's an amazing website.
Thanks!
|
see side of box:
http://www.brickshelf.com/cgi-bin/gallery.cgi?i=3181942
Stefaan
|
|
|
| | | | | | | | | |
| | | | | | | Author: | rimwall | | Posted: | Aug 4, 2020 22:47 | | Subject: | Re: Inventory Change Request for Set 6841-1 | | Viewed: | 22 times | | Topic: | Inventories Requests | |
|
| In Inventories Requests, elias3 writes:
| | In Inventories Requests, rimwall writes:
| | Please make changes to the following inventory:
* Change 1 Part Light Gray {3039p34 Slope 45 2 x 2 with Computer Panel Pattern to 3039 Slope 45 2 x 2}
Comments from Submitter:
Hi,
I think this 2 x 2 slope part should be plain 3039 (no computer panel printed). I can't see any evidence in the instructions or on images of the box that it has a printed computer panel. If there are printed parts that can't be seen, the instructions normally have an extra picture in a box showing the printed face. That is not the case here.
Keep up the good work at BrickLink - it's an amazing website.
Thanks!
|
see side of box:
http://www.brickshelf.com/cgi-bin/gallery.cgi?i=3181942
Stefaan
|
Ahhh, yes, I see! I could only find images of the top of the box, not the side.
So please ignore my change request.
Thanks!
|
|
|
|
|
|
|
Australia, Queensland
Belgium, Oost-Vlaanderen
