| Discussion Forum: Thread 244436 |
|
 |
| | | Author: | BricksThatStick  | | Posted: | Nov 15, 2018 16:29 | | Subject: | Inventory Change Request for Set 6482-1 | | Viewed: | 26 times | | Topic: | Inventories Requests (Entry) | | Status: | Open | |
|
| Please make changes to the following inventory:
* Change 4 Part Red {3044 Slope 45 2 x 1 Double - (MARKED FOR DELETION - Undetermined Underside Version) to 3044a Slope 45 2 x 1 Double - without Bottom Pin}
|
|
| | | | | |
| | | | | Author: | randyf | | Posted: | Nov 15, 2018 22:24 | | Subject: | Re: Inventory Change Request for Set 6482-1 | | Viewed: | 23 times | | Topic: | Inventories Requests | |
|
| In Inventories Requests, BricksThatStick writes:
| | Please make changes to the following inventory:
* Change 4 Part Red {3044 Slope 45 2 x 1 Double - (MARKED FOR DELETION - Undetermined Underside Version) to 3044a Slope 45 2 x 1 Double - without Bottom Pin}
|
I have a couple of questions before I can approve this change:
(1) Did you build this set from sealed set contents or was it obtained as a used
set?
(2) If you built it from sealed set contents, were the pieces always left unmixed
with other sets?
Thanks for your assistance!
Cheers,
Randy
|
|
| | | | | | | | | |
| | | | | | | Author: | BricksThatStick | | Posted: | Nov 16, 2018 12:37 | | Subject: | Re: Inventory Change Request for Set 6482-1 | | Viewed: | 20 times | | Topic: | Inventories Requests | |
|
| In Inventories Requests, randyf writes:
| | In Inventories Requests, BricksThatStick writes:
| | Please make changes to the following inventory:
* Change 4 Part Red {3044 Slope 45 2 x 1 Double - (MARKED FOR DELETION - Undetermined Underside Version) to 3044a Slope 45 2 x 1 Double - without Bottom Pin}
|
I have a couple of questions before I can approve this change:
(1) Did you build this set from sealed set contents or was it obtained as a used
set?
(2) If you built it from sealed set contents, were the pieces always left unmixed
with other sets?
Thanks for your assistance!
Cheers,
Randy
|
Sorry should have clarified when submitted...
Its a set from childhood collection that has been built since then (actually
half broken down but the wheel assemblies with slopes on top were all intact)
No other sets from collection had these slopes.
|
|
|
| | | | | | | | | | | | | |
| | | | | | | | | Author: | randyf | | Posted: | Nov 16, 2018 12:56 | | Subject: | Re: Inventory Change Request for Set 6482-1 | | Viewed: | 25 times | | Topic: | Inventories Requests | |
|
| In Inventories Requests, BricksThatStick writes:
| | In Inventories Requests, randyf writes:
| | In Inventories Requests, BricksThatStick writes:
| | Please make changes to the following inventory:
* Change 4 Part Red {3044 Slope 45 2 x 1 Double - (MARKED FOR DELETION - Undetermined Underside Version) to 3044a Slope 45 2 x 1 Double - without Bottom Pin}
|
I have a couple of questions before I can approve this change:
(1) Did you build this set from sealed set contents or was it obtained as a used
set?
(2) If you built it from sealed set contents, were the pieces always left unmixed
with other sets?
Thanks for your assistance!
Cheers,
Randy
|
Sorry should have clarified when submitted...
Its a set from childhood collection that has been built since then (actually
half broken down but the wheel assemblies with slopes on top were all intact)
No other sets from collection had these slopes.
|
That is what I needed to know. Thanks again, and request approved. 
Cheers,
Randy
|
|
|
|
|
|
|
United Kingdom, England
USA, Ohio
