My fingers and thumbs are painful already and I've only just started lol
Do you have any tips for dismantling old Lego technic sets especially the old
toothed bushes 4265 is the most painful to my hands to separate!
The chisel end of a brick separator can be useful to get into tight fitting regions
and gently tease apart before using your fingers. A longer axle is also a useful
tool for pushing out pins. If you have the instructions working backwards can
also help where it is not clear how something was put together. Occasionally
you get sets where it is not obvious which bit to tackle first. Having a small
square of fabric doubled over can also help when needing to pull things off axles
or out of tight spots as it stops them digging into your fingers.
My fingers and thumbs are painful already and I've only just started lol
Do you have any tips for dismantling old Lego technic sets especially the old
toothed bushes 4265 is the most painful to my hands to separate!
I work on technic bit by bit usually. Takes me a few days to do.
If I can, I find pushing the axle through a technic beam can help remove the
old bushes, but only if there’s just one on an axle.
I use a piece of fabric or some soft gloves if I think my fingers will get a
bit sore when pulling pieces apart.
I’m just about to dismantle my old backhoe grader and dreading it, old technic
pieces have some serious clutch power!
My fingers and thumbs are painful already and I've only just started lol
Do you have any tips for dismantling old Lego technic sets especially the old
toothed bushes 4265 is the most painful to my hands to separate!
Ow ow ow! Can't do it lol
Push through from the underside with a longer technic axle
That should transfer the bush off the pin and on to the axle
Then pull the axle through the hole of a technic brick or liftarm
My fingers and thumbs are painful already and I've only just started lol
Do you have any tips for dismantling old Lego technic sets especially the old
toothed bushes 4265 is the most painful to my hands to separate!
For some really stubborn ones I resorted to two pairs of pliers, and a soft touch
on gripping the parts. That was a long time ago, though. Smooth grip needle nose
pliers worked really well for small LEGO parts that were too stubborn to budge
otherwise.
Worked every time. Now all I need to do is remember to look for pliers imprints
on parts should I ever list them again. I don't think I will list them again,
though!
For some really stubborn ones I resorted to two pairs of pliers, and a soft touch
on gripping the parts. That was a long time ago, though. Smooth grip needle nose
pliers worked really well for small LEGO parts that were too stubborn to budge
otherwise.
This works great with a piece of cloth and does not leave marks.
United Kingdom, England
USA, Illinois
Italy, Marche
Denmark
Netherlands, Groningen
Australia, Queensland