Discussion Forum: Thread 253432

 Author: bb1415098 View Messages Posted By bb1415098
 Posted: Jun 12, 2019 06:54
 Subject: There should really be an FOV slider!
 Viewed: 126 times
 Topic: Suggestions
 Status:Open
 Vote:[Yes|No]
Cancel Message
Cancel		Reply to Message
Reply
BrickLink
ID Card

bb1415098 (0)

Location:  USA, APO/FPO
Member Since Contact Type Status
Jun 12, 2019 Contact Member Buyer
No Longer Registered
No Longer Registered
I apologize if this is for suggestions for the website specifically, but I couldn't
find where to submit suggestions for the Bricklink Studio program itself. The
field of view in the view port is waaaay too narrow. If possible, a simple FOV
slider that goes up to at least 90 degrees would be enough to make using the
Studio program so much more easier, not only so I can see more but it so it won't
make me nearly as dizzy to use. Thanks for reading this, and I again apologize
if this was the wrong place to post this but I couldn't find any other place
to suggest this.
 Author: SylvainLS View Messages Posted By SylvainLS
 Posted: Jun 12, 2019 07:20
 Subject: Re: There should really be an FOV slider!
 Viewed: 47 times
 Topic: Suggestions
Cancel Message
Cancel		Reply to Message
Reply
BrickLink
ID Card

SylvainLS (46)

Location:  France, Nouvelle-Aquitaine
Member Since Contact Type Status
Apr 25, 2014 Contact Member Seller
Buying Privileges - OKSelling Privileges - OK
Store Closed Store: BuyerOnly
BrickLink Discussions Moderator (?)
In Suggestions, DeLeSepTep writes:
  I apologize if this is for suggestions for the website specifically, but I couldn't
find where to submit suggestions for the Bricklink Studio program itself.
[…] Thanks for reading this, and I again apologize
if this was the wrong place to post this but I couldn't find any other place
to suggest this.

http://forum.bricklink.com/