Discussion Forum: Thread 242727 |
|
|
| | Author: | Skylar2010 | Posted: | Oct 7, 2018 17:28 | Subject: | technic pins | Viewed: | 121 times | Topic: | Catalog | Status: | Open | |
|
| how are technic pins measured? or how do i know I am looking at right size? |
|
| | | | | |
| | | | Author: | SylvainLS | Posted: | Oct 7, 2018 17:47 | Subject: | Re: technic pins | Viewed: | 28 times | Topic: | Catalog | |
|
| In LEGO, Skylar2010 writes:
| how are technic pins measured? or how do i know I am looking at right size?
|
Ah, yes, BL’s catalogue measure them in “pins.”
That is, “full” pins are:
They are 2 studs-long (= 2L). (1L = 1 stud = the width of a brick = LEGO’s “Module”
or “M”.)
So, the “half pin”,
is actually a 1 stud-long “thing that goes in technic holes” with a stud on top.
And the “¾ pin” is a 1½ stud-long part = a 1-stud-long thing that goes in technic
holes and a half-stud-long one that goes in thin/half beams
Then, when “L” is used, it’s in studs.
So, if the catalogue were coherent, the following parts would be called “1½ pins”
Axles are in studs.
|
|
|
| | | | | |
| | | | Author: | romax1989 | Posted: | Oct 7, 2018 17:48 | Subject: | Re: technic pins | Viewed: | 22 times | Topic: | Catalog | |
|
| In LEGO, Skylar2010 writes:
| how are technic pins measured? or how do i know I am looking at right size?
|
Pins are easy just look at pictures in catalogue.
I think they are measured by stud length like techinic axles.
|
|
| | | | | |
| | | | Author: | mwright5 | Posted: | Oct 7, 2018 17:50 | Subject: | Re: technic pins | Viewed: | 29 times | Topic: | Catalog | |
|
| In LEGO, Skylar2010 writes:
| how are technic pins measured? or how do i know I am looking at right size?
|
I thought you were going out of town? LOL They are measured in terms of studs
long. Place next to a plate and count how many studs long the axle is.
Sounds like my previous advice didn't have any impact. Oh well, welcome
aboard.
|
|
| | | | | | | | | |
| | | | | | Author: | Skylar2010 | Posted: | Oct 7, 2018 18:56 | Subject: | Re: technic pins | Viewed: | 39 times | Topic: | Catalog | |
|
| In LEGO, mwright5 writes:
| In LEGO, Skylar2010 writes:
| how are technic pins measured? or how do i know I am looking at right size?
|
I thought you were going out of town? LOL They are measured in terms of studs
long. Place next to a plate and count how many studs long the axle is.
Sounds like my previous advice didn't have any impact. Oh well, welcome
aboard.
|
Hi mright. I am calmer and about going out it town applies to next weekend not
this one.
but i do think i might becoming addicted to looking uo stuff in the catalogue
lol.
however, I should be watching tv later to night and we did visit with friends
this afternoon.
|
|
|
|
|
|