* Add 4 Part 4215a Red Panel 1 x 4 x 3 - Solid Studs (Alternate)
Comments from Submitter:
4 red panels are used for the container, but the sickered version is not listed. I cant find it as an item either, can provide picture of part if needed, set i do not have but part is slightly visible on picture of the set and sticker is seen on sticker sheet
* Add 4 Part 4215a Red Panel 1 x 4 x 3 - Solid Studs (Alternate)
Comments from Submitter:
4 red panels are used for the container, but the sickered version is not listed. I cant find it as an item either, can provide picture of part if needed, set i do not have but part is slightly visible on picture of the set and sticker is seen on sticker sheet
Hi
No…
The sticker is glued over the 1x4 and 1x2 panel. Since this is not valid as a
sticker part, no sticker part has been uploaded for the red panel.
A combination of multiple parts can be made. The plates should also be added
to the part.
* Add 4 Part 4215a Red Panel 1 x 4 x 3 - Solid Studs (Alternate)
Comments from Submitter:
4 red panels are used for the container, but the sickered version is not listed. I cant find it as an item either, can provide picture of part if needed, set i do not have but part is slightly visible on picture of the set and sticker is seen on sticker sheet
This request will not be accepted.
The proper procedure to add a stickered Counterpart to BrickLink and a set inventory
is as follows:
(1) Add the stickered part to the BrickLink catalog:
(3) Fill out an Inventory Change Request to add the stickered part to the set
inventory after it is approved by a Catalog Associate or Catalog Administrator:
Also, since the items here would be considered stickered assemblies (a sticker
or stickers across multiple parts), they would need to be submitted as such.
The following category of items can be used to scan for examples of how they
are done:
Netherlands, Gelderland
Belgium, Oost-Vlaanderen
USA, Ohio
