Discussion Forum: Thread 351534

 Author: centexbricks View Messages Posted By centexbricks
 Posted: Dec 14, 2023 19:47
 Subject: Should part #2335px15 be separated into two?
 Viewed: 82 times
 Topic: Catalog Requests
 For:Catalog Associate
 Status:Completed
Cancel Message
Cancel		Reply to Message
Reply
BrickLink
ID Card

centexbricks (144)

Location:  USA, Texas
Member Since Contact Type Status
Jan 13, 2021 Contact Member Buyer
Buying Privileges - OK
Both parts in the attached photo are listed under part 2335px15. However, as
you can see, the printing is slightly different between the two.

The part on the left is the light bluish gray version found in set "9679
AT-ST & Endor". On this version the small ovals at the top, the small hexagon,
and the large hexagon are all printed in gray.

The part on the right is the light gray version found in set "4486 AT-ST
& Snowspeeder - Mini". On this version the small ovals at the top, the small
hexagon, and the large hexagon are all printed in black. In addition, the small
ovals at the top are essentially joined to the large box below them.

Also, the two flags use different molds as well.
 
 Author: TakeAbricK View Messages Posted By TakeAbricK
 Posted: Dec 15, 2023 01:24
 Subject: Re: Should part #2335px15 be separated into two?
 Viewed: 30 times
 Topic: Catalog Requests
Cancel Message
Cancel		Reply to Message
Reply
BrickLink
ID Card

TakeAbricK (13452)

Location:  Netherlands, Gelderland
Member Since Contact Type Status
Jan 12, 2007 Contact Member Seller
Buying Privileges - OKSelling Privileges - OK
Store: TakeAbricK
BrickLink Catalog Associate (?)
In Catalog Requests, centexbricks writes:
  Both parts in the attached photo are listed under part 2335px15. However, as
you can see, the printing is slightly different between the two.

The part on the left is the light bluish gray version found in set "9679
AT-ST & Endor". On this version the small ovals at the top, the small hexagon,
and the large hexagon are all printed in gray.

The part on the right is the light gray version found in set "4486 AT-ST
& Snowspeeder - Mini". On this version the small ovals at the top, the small
hexagon, and the large hexagon are all printed in black. In addition, the small
ovals at the top are essentially joined to the large box below them.

Also, the two flags use different molds as well.

Yes, this part definitely needs to be split. Thanks for catching this.
 
Part No: 2335px15 Name: Flag 2 x 2 Square with Black SW MINI AT-ST Pattern
* 		2335px15 Flag 2 x 2 Square with Black SW MINI AT-ST Pattern
Parts: Flag, Decorated

The molds are under the same catalog entry, so they will get the same item number
though.

Thanks,
Diana