Discussion Forum: Thread 340425

 Author: crocushorselady View Messages Posted By crocushorselady
 Posted: May 27, 2023 15:49
 Subject: Images not showing on part inventory
 Viewed: 59 times
 Topic: Inventories
 Status:Open
Cancel Message
Cancel		Reply to Message
Reply
BrickLink
ID Card

crocushorselady (8)

Location:  Canada, Manitoba
Member Since Contact Type Status
May 10, 2023 Contact Member Seller
Buying Privileges - OKSelling Privileges - OK
Store Closed Store: The Bygone Bricks Shoppe
On this page: https://www.bricklink.com/catalogItemInv.asp?fromForm=Y&itemType=P&itemNo=18978&itemSeq=1
The images for the parts it is made up of are not showing, only 'image not
available' even though the images exist (you can see them by clicking on
the parts and going to their page)
 Author: Nubs_Select View Messages Posted By Nubs_Select
 Posted: May 27, 2023 17:22
 Subject: Re: Images not showing on part inventory
 Viewed: 22 times
 Topic: Inventories
Cancel Message
Cancel		Reply to Message
Reply
BrickLink
ID Card

Nubs_Select (3729)

Location:  Canada, Ontario
Member Since Contact Type Status
Mar 15, 2016 Contact Member Seller
Buying Privileges - OKSelling Privileges - OK
Store: Nub's Select
likely since the colour isnt set
 Author: SylvainLS View Messages Posted By SylvainLS
 Posted: May 27, 2023 17:33
 Subject: Re: Images not showing on part inventory
 Viewed: 28 times
 Topic: Inventories
Cancel Message
Cancel		Reply to Message
Reply
BrickLink
ID Card

SylvainLS (46)

Location:  France, Nouvelle-Aquitaine
Member Since Contact Type Status
Apr 25, 2014 Contact Member Seller
Buying Privileges - OKSelling Privileges - OK
Store Closed Store: BuyerOnly
BrickLink Discussions Moderator (?)
In Technical Issues, Nubs_Select writes:
  likely since the colour isnt set

I think we already had a thread about that.

The multipack has a colour in the inventories it’s in, so it shows correctly
(example https://www.bricklink.com/catalogItemInv.asp?S=75894-1 ).

And when you follow the link to the multipack’s page, it’s in the correct colour
(example https://www.bricklink.com/v2/catalog/catalogitem.page?P=18978&idColor=1#T=P&C=1
).

But then, when you look at the inventory of the multipack, the colour isn’t used
/ propagated, because the parts do have a colour in that inventory: the Not Applicable
colour.

There’s an image in the popup (when you click the (non-)image) because the popup
show a default image (not the colour of the part in the inventory, except by
happenstance).

If you follow the link to one of the parts, it propagates the Not Applicable
colour that’s in the inventory and, therefore, there’s no image either.