Discussion Forum: Thread 339336

 Author: pcthurman View Messages Posted By pcthurman
 Posted: May 7, 2023 00:21
 Subject: Spring is building 23
 Viewed: 56 times
 Topic: Events
Cancel Message
Cancel		Reply to Message
Reply
BrickLink
ID Card

pcthurman (1195)

Location:  USA, Virginia
Member Since Contact Type Status
Apr 20, 2004 Contact Member Buyer
Buying Privileges - OK
I created a MOC for the Spring is building 23 event. It is my first time using
Studio. I have uploaded the design into "My Studio" on Bricklink but
I cannot figure out how to enter it into the event. I have used the tag springisbuilding23.

What am I missing?

Cass T
 Author: SylvainLS View Messages Posted By SylvainLS
 Posted: May 7, 2023 07:46
 Subject: Re: Spring is building 23
 Viewed: 31 times
 Topic: Events
Cancel Message
Cancel		Reply to Message
Reply
BrickLink
ID Card

SylvainLS (46)

Location:  France, Nouvelle-Aquitaine
Member Since Contact Type Status
Apr 25, 2014 Contact Member Seller
Buying Privileges - OKSelling Privileges - OK
Store Closed Store: BuyerOnly
BrickLink Discussions Moderator (?)
In Events, pcthurman writes:
  I created a MOC for the Spring is building 23 event. It is my first time using
Studio. I have uploaded the design into "My Studio" on Bricklink but
I cannot figure out how to enter it into the event. I have used the tag springisbuilding23.

What am I missing?

Cass T

I can’t see any MOC when searching fo your ID.  Uploading to My Studio isn’t
enough, you need to publish it: https://studiohelp.bricklink.com/hc/en-us/articles/5705436653847-Publishing-in-the-Gallery
 Author: pcthurman View Messages Posted By pcthurman
 Posted: May 7, 2023 17:33
 Subject: Re: Spring is building 23
 Viewed: 62 times
 Topic: Events
Cancel Message
Cancel		Reply to Message
Reply
BrickLink
ID Card

pcthurman (1195)

Location:  USA, Virginia
Member Since Contact Type Status
Apr 20, 2004 Contact Member Buyer
Buying Privileges - OK
In Events, SylvainLS writes:
  In Events, pcthurman writes:
  I created a MOC for the Spring is building 23 event. It is my first time using
Studio. I have uploaded the design into "My Studio" on Bricklink but
I cannot figure out how to enter it into the event. I have used the tag springisbuilding23.

What am I missing?

Cass T

I can’t see any MOC when searching fo your ID.  Uploading to My Studio isn’t
enough, you need to publish it: https://studiohelp.bricklink.com/hc/en-us/articles/5705436653847-Publishing-in-the-Gallery

Thank you!