Discussion Forum: Thread 338259 |
|
|
| | Author: | mandynicholls78 | Posted: | Apr 16, 2023 17:06 | Subject: | can you help me join these! | Viewed: | 123 times | Topic: | Problem | |
|
| I would like to turn the clear plate around so it fits edge to edge, but as the
centres are both able to receive a stud they don't fit. Is there a stud to
stud joint? i cant use a bar as the bar with claw isnt long enough to go through
the grey to then hold the inverted clear. I need some form of claw on the back
hence the stud on the rear as its being mounted to a bar.
Thanks
Mandy
|
|
|
| | | | | |
| | | | Author: | LeeGo73 | Posted: | Apr 16, 2023 17:12 | Subject: | Re: can you help me join these! | Viewed: | 50 times | Topic: | Problem | |
|
| In Problem, mandynicholls78 writes:
| I would like to turn the clear plate around so it fits edge to edge, but as the
centres are both able to receive a stud they don't fit. Is there a stud to
stud joint? i cant use a bar as the bar with claw isnt long enough to go through
the grey to then hold the inverted clear. I need some form of claw on the back
hence the stud on the rear as its being mounted to a bar.
Thanks
Mandy
|
maybe these:
or
|
|
| | | | | |
| | | | Author: | wyvern | Posted: | Apr 16, 2023 18:15 | Subject: | Re: can you help me join these! | Viewed: | 51 times | Topic: | Problem | |
|
| I know you want a clip on the end, but depending on the build you're working
with, you can use this part:
and then maybe you can replace the bar or whatever it's supposed to clip
to with one of these parts:
Yes it actually does fit that last one! I've seen that combo before, but
I don't remember where. Whether it was in an official set or not, Stud.io
treats that connection like any other joint, so I would say it's perfectly
"legal"
|
|
|
| | | | | | | | | |
| | | | | | Author: | mandynicholls78 | Posted: | Apr 17, 2023 14:21 | Subject: | Re: can you help me join these! | Viewed: | 29 times | Topic: | Problem | |
|
| Brilliant, Thankyou. I will get one of those on order to try. I like the twin
claw option as that should fit better with my build design where im trying to
get 3 of these lights spaced across 10 stud width.
Mandy
In Problem, wyvern writes:
| I know you want a clip on the end, but depending on the build you're working
with, you can use this part:
and then maybe you can replace the bar or whatever it's supposed to clip
to with one of these parts:
Yes it actually does fit that last one! I've seen that combo before, but
I don't remember where. Whether it was in an official set or not, Stud.io
treats that connection like any other joint, so I would say it's perfectly
"legal"
|
|
|
|
|
|
|
|