Discussion Forum: Thread 338234

 Author: tanman View Messages Posted By tanman
 Posted: Apr 16, 2023 06:40
 Subject: Change Instruction (adding Item Dimensions)
 Viewed: 41 times
 Topic: Catalog
 Status:Open
Cancel Message
Cancel		Reply to Message
Reply
BrickLink
ID Card

tanman (3366)

Location:  Denmark
Member Since Contact Type Status
Oct 16, 2000 Contact Member Seller
Buying Privileges - OKSelling Privileges - OK
Store: Bricks on the Plate
I want to add dimensions to som instruction booklets.

On the https://www.bricklink.com/catalogAdd.asp page instructions are not an
option. Which leads me believe that "Part" - https://www.bricklink.com/catalogReq.asp?itemType=P
is the option to use. In that case, what "Item No" should I use?
 Author: hpoort View Messages Posted By hpoort
 Posted: Apr 16, 2023 06:56
 Subject: Re: Change Instruction (adding Item Dimensions)
 Viewed: 23 times
 Topic: Catalog
Cancel Message
Cancel		Reply to Message
Reply
BrickLink
ID Card

hpoort (410)

Location:  Netherlands, Groningen
Member Since Contact Type Status
Oct 11, 2014 Contact Member Buyer
Buying Privileges - OK
In Catalog, tanman writes:
  I want to add dimensions to som instruction booklets.

On the https://www.bricklink.com/catalogAdd.asp page instructions are not an
option. Which leads me believe that "Part" - https://www.bricklink.com/catalogReq.asp?itemType=P
is the option to use. In that case, what "Item No" should I use?

https://www.bricklink.com/catalogReq.asp?itemType=S

The option to change instruction dimensions is hidden behind the 'Change
set' option.
 Author: tanman View Messages Posted By tanman
 Posted: Apr 16, 2023 07:28
 Subject: Re: Change Instruction (adding Item Dimensions)
 Viewed: 25 times
 Topic: Catalog
Cancel Message
Cancel		Reply to Message
Reply
BrickLink
ID Card

tanman (3366)

Location:  Denmark
Member Since Contact Type Status
Oct 16, 2000 Contact Member Seller
Buying Privileges - OKSelling Privileges - OK
Store: Bricks on the Plate
In Catalog, hpoort writes:
  In Catalog, tanman writes:
  I want to add dimensions to som instruction booklets.

On the https://www.bricklink.com/catalogAdd.asp page instructions are not an
option. Which leads me believe that "Part" - https://www.bricklink.com/catalogReq.asp?itemType=P
is the option to use. In that case, what "Item No" should I use?

https://www.bricklink.com/catalogReq.asp?itemType=S

The option to change instruction dimensions is hidden behind the 'Change
set' option.

Found it! Thank you for the quick reply