Discussion Forum: Thread 291547

 Author: einsteinsedge View Messages Posted By einsteinsedge
 Posted: Jun 18, 2021 19:22
 Subject: Cannot get out of part selection screen
 Viewed: 52 times
 Topic: Help
Cancel Message
Cancel		Reply to Message
Reply
BrickLink
ID Card

einsteinsedge (3)

Location:  USA, Arizona
Member Since Contact Type Status
May 1, 2021 Contact Member Buyer
Buying Privileges - OK
The list of parts fills my whole screen. Have tried to drag/double click just
about every pixel on my display. Nothing reduces it. Just see parts selection
with my design stuck behind it. Has anyone seen this before? I've tried esc
and tab to no effect.
 Author: wildchicken13 View Messages Posted By wildchicken13
 Posted: Jun 18, 2021 21:38
 Subject: Re: Cannot get out of part selection screen
 Viewed: 21 times
 Topic: Help
Cancel Message
Cancel		Reply to Message
Reply
BrickLink
ID Card

wildchicken13 (875)

Location:  USA, Illinois
Member Since Contact Type Status
Aug 11, 2014 Contact Member Seller
Buying Privileges - OKSelling Privileges - OK
Store: Wild Chicken
In Help, einsteinsedge writes:
  The list of parts fills my whole screen. Have tried to drag/double click just
about every pixel on my display. Nothing reduces it. Just see parts selection
with my design stuck behind it. Has anyone seen this before? I've tried esc
and tab to no effect.

The dedicated Studio forum is here: https://forum.bricklink.com/