Discussion Forum: Thread 287090

 Author: madelinecreates View Messages Posted By madelinecreates
 Posted: Mar 29, 2021 06:29
 Subject: (Cancelled)
 Viewed: 37 times
 Topic: Related Software
Cancel Message
Cancel
Reply to Message
Reply
BrickLink
ID Card

madelinecreates (0) 

Location:  Netherlands, Utrecht
Member Since Contact Type Status
Mar 28, 2021 Contact Member Buyer
Buying Privileges - OK
(Cancelled)
 Author: hpoort View Messages Posted By hpoort
 Posted: Mar 29, 2021 07:15
 Subject: Re: Part Designer minifig design question
 Viewed: 31 times
 Topic: Related Software
Cancel Message
Cancel
Reply to Message
Reply
BrickLink
ID Card

hpoort (405)

Location:  Netherlands, Groningen
Member Since Contact Type Status
Oct 11, 2014 Contact Member Buyer
Buying Privileges - OK
In Help, madelinecreates writes:
  Hi there!

I'm new to the forum and started designing my own minifigure using Part Designer.
However, I can't find a location to ask my question about it. If this is
the wrong place, please let me know where I should ask it instead.

As for my question: I can't put a design on the side of my figure. For this
design I don't need to put anything on the arms, but I do would like to put
a design on the side of the pants (circle + top/straight part (like a belt))
and side torso. Is this possible, and if so, how do I do that? When I select
the torso I can only add a design to the front and back and for the legs the
circle part and top part aren't included (I can only add the top part to
the front and back).


Best wishes,
Madeline

You posted on the Bricklink Marketplace forum; there is another forum on which
to post about Studio and PartDesigner: https://forum.bricklink.com

As to your question, this thread may help you get started: https://forum.bricklink.com/viewtopic.php?f=10&t=6326