Discussion Forum: Thread 270575

 Author: LBBDE View Messages Posted By LBBDE
 Posted: Jun 28, 2020 06:25
 Subject: StudIO shape category update
 Viewed: 32 times
 Topic: Related Software
Cancel Message
Cancel
Reply to Message
Reply
BrickLink
ID Card

LBBDE (16)

Location:  Germany, Nordrhein-Westfalen
Member Since Contact Type Status
Mar 24, 2016 Contact Member Buyer
Buying Privileges - OK
With the last update for StudIO, the shapes for the bricks have also changed
(to keep them consistent with the categories on BrickLink). However, I found
that the original sorting was actually very good because the bricks were sorted
according to 'usefulness'. First the bricks, then the special bricks,
then plates and so on. Since the new update, I have to jump back and forth a
lot more when looking for parts in the list. Therefore, I wonder if it would
not be possible to return the original sorting as an additional category, for
example as 'classic shapes', 'original shapes' or 'StudIO
shapes'.
I am new here in the forum and therefore do not know where I can best give feedback
to the developers.
 Author: Brickwilbo View Messages Posted By Brickwilbo
 Posted: Jun 28, 2020 06:31
 Subject: Re: StudIO shape category update
 Viewed: 17 times
 Topic: Related Software
Cancel Message
Cancel
Reply to Message
Reply
BrickLink
ID Card

Brickwilbo (1484)

Location:  Netherlands, Gelderland
Member Since Contact Type Status Collage
Oct 24, 2007 Contact Member Seller
Buying Privileges - OKSelling Privileges - OK
View Collage Pic
Store: Brickwilbo Betuwe Bricks
BrickLink Discussions Moderator (?)
In Related Software, LBBDE writes:
  With the last update for StudIO, the shapes for the bricks have also changed
(to keep them consistent with the categories on BrickLink). However, I found
that the original sorting was actually very good because the bricks were sorted
according to 'usefulness'. First the bricks, then the special bricks,
then plates and so on. Since the new update, I have to jump back and forth a
lot more when looking for parts in the list. Therefore, I wonder if it would
not be possible to return the original sorting as an additional category, for
example as 'classic shapes', 'original shapes' or 'StudIO
shapes'.
I am new here in the forum and therefore do not know where I can best give feedback
to the developers.

The dedicated Studio forum is here https://forum.bricklink.com/