Discussion Forum: Thread 261206 |
|
|
| | Author: | normann1974 | Posted: | Dec 14, 2019 09:08 | Subject: | Inventory Change Request for Set 4819-1 | Viewed: | 27 times | Topic: | Inventories Requests (Entry) | Status: | Open | |
|
| Please make changes to the following inventory:
* Change 2 Part Dark Gray {30359 Bar 1 x 8 with Brick 1 x 2 Curved Top End (Undetermined Type) to 30359a Bar 1 x 8 with Brick 1 x 2 Curved Top End (Original, No Axle Holder)}
Comments from Submitter:
Source: Unboxing from BS: http://www.brickshelf.com/cgi-bin/gallery.cgi?i=2840458. Detailed documentation follows as follow-up to this thread.
|
|
| | | | | |
| | | | Author: | normann1974 | Posted: | Dec 14, 2019 09:09 | Subject: | Re: Inventory Change Request for Set 4819-1 | Viewed: | 25 times | Topic: | Inventories Requests | |
|
| In Inventories Requests, normann1974 writes:
| Please make changes to the following inventory:
* Change 2 Part Dark Gray {30359 Bar 1 x 8 with Brick 1 x 2 Curved Top End (Undetermined Type) to 30359a Bar 1 x 8 with Brick 1 x 2 Curved Top End (Original, No Axle Holder)}
Comments from Submitter:
Source: Unboxing from BS: http://www.brickshelf.com/cgi-bin/gallery.cgi?i=2840458. Detailed documentation follows as follow-up to this thread.
|
If there was an axle holder inside, it should be visible from the photo angle
(example in picture). If not convinced, feel free to reject this request.
/Jan
|
|
|
|
| | | | | | | | | |
| | | | | | Author: | randyf | Posted: | Dec 16, 2019 04:15 | Subject: | Re: Inventory Change Request for Set 4819-1 | Viewed: | 25 times | Topic: | Inventories Requests | |
|
| In Inventories Requests, normann1974 writes:
| In Inventories Requests, normann1974 writes:
| Please make changes to the following inventory:
* Change 2 Part Dark Gray {30359 Bar 1 x 8 with Brick 1 x 2 Curved Top End (Undetermined Type) to 30359a Bar 1 x 8 with Brick 1 x 2 Curved Top End (Original, No Axle Holder)}
Comments from Submitter:
Source: Unboxing from BS: http://www.brickshelf.com/cgi-bin/gallery.cgi?i=2840458. Detailed documentation follows as follow-up to this thread.
|
If there was an axle holder inside, it should be visible from the photo angle
(example in picture). If not convinced, feel free to reject this request.
/Jan
|
Yeah, I'm not entirely convinced. There is a shadow in the end of the part
in the photo of the set that may be obscuring what little bit of the axle ridges
we might be able to see at that angle. I would rather wait for more convincing
evidence. Thanks for the attempt, though!
Cheers,
Randy
|
|
|
|
|
|
|