Discussion Forum: Thread 259637 |
|
|
| | Author: | waltzking | Posted: | Nov 11, 2019 01:01 | Subject: | Inventory Change Request for Set 10194-1 | Viewed: | 30 times | Topic: | Inventories Requests (Entry) | Status: | Open | |
|
| Please make changes to the following inventory:
* Change {7 to 8} Part Tan 6541 Technic, Brick 1 x 1 with Hole
Comments from Submitter:
Instruction pages 6, 44 & 48 of book 1 show the need for 8 of these parts (as was also evidenced when taking apart my built model from a sealed kit I had built and then stored for the last 10-years.)
|
|
| | | | | | | | | | |
| | | | | | Author: | randyf | Posted: | Nov 16, 2019 14:00 | Subject: | Re: Inventory Change Request for Set 10194-1 | Viewed: | 20 times | Topic: | Inventories Requests | |
|
| In Inventories Requests, Turez writes:
Jonas -
Thank you very much for providing the information I needed to look into this
quickly.
Cheers,
Randy
|
|
|
| | | | | |
| | | | Author: | randyf | Posted: | Nov 16, 2019 14:28 | Subject: | Re: Inventory Change Request for Set 10194-1 | Viewed: | 26 times | Topic: | Inventories Requests | |
|
| In Inventories Requests, waltzking writes:
| Please make changes to the following inventory:
* Change {7 to 8} Part Tan 6541 Technic, Brick 1 x 1 with Hole
Comments from Submitter:
Instruction pages 6, 44 & 48 of book 1 show the need for 8 of these parts (as was also evidenced when taking apart my built model from a sealed kit I had built and then stored for the last 10-years.)
|
Thank you for coming forward with this change!
As Jonas showed in his response to your request, the set was redesigned during
production to stabilize a gear that can slip off an axle under load when the
engine is converted over to Power Functions.
I have updated the inventory with the correct changes needed to account for the
redesign and updated the inventory note for the set. As such, this request will
not be accepted.
Cheers,
Randy
|
|
|
|
|
|
|