Discussion Forum: Thread 253668

 Author: crazylegoman View Messages Posted By crazylegoman
 Posted: Jun 17, 2019 20:35
 Subject: New part that doesn't exist without printing
 Viewed: 107 times
 Topic: Catalog
 Status:Open
Cancel Message
Cancel		Reply to Message
Reply
BrickLink
ID Card

crazylegoman (1088)

Location:  USA, Indiana
Member Since Contact Type Status Collage
Apr 1, 2001 Contact Member Seller
Buying Privileges - OKSelling Privileges - OK
 View Collage Pic
Store: Hoosier Daddy
There's a new part I want to add to the catalog, and so far it only exists
with a printing on it. Is the proper procedure to add a sort of "placeholder"
entry for the actual new mold/part that has no printing, and then add the new
printed part that I have? I will upload a photo of the printed version I have,
but of course, cannot for the base part.

Thanks,
David
 Author: yorbrick View Messages Posted By yorbrick
 Posted: Jun 18, 2019 04:19
 Subject: Re: New part that doesn't exist without printing
 Viewed: 45 times
 Topic: Catalog
Cancel Message
Cancel		Reply to Message
Reply
BrickLink
ID Card

yorbrick (1181)

Location:  United Kingdom, England
Member Since Contact Type Status
Apr 11, 2011 Contact Member Seller
Buying Privileges - OKSelling Privileges - OK
Store: Yorbricks
In Catalog, crazylegoman writes:
  There's a new part I want to add to the catalog, and so far it only exists
with a printing on it. Is the proper procedure to add a sort of "placeholder"
entry for the actual new mold/part that has no printing, and then add the new
printed part that I have? I will upload a photo of the printed version I have,
but of course, cannot for the base part.

Thanks,
David

I believe you can only submit the printed part, as that is what exists.